Compression Tests
Mostrando 1-12 de 301 artigos, teses e dissertações.
-
1. Strain analysis in diametral compression test through digital image correlation
Abstract In the search for alternatives to obtain more information from rock tests and to make them more accessible, this study applies the Digital Image Correlation technique (DIC 2D) in a diametral compression test called Brazilian Test, comparing the result measured by an extensometer with the result obtained by DIC. Rock tests provide information about r
REM - International Engineering Journal. Publicado em: 2022
-
2. Epistaxis in a Pediatric Outpatient Clinic: Could It be an Alarming Sign?
Abstract Introduction Epistaxis is a common presentation among children. Objective To investigate the suitability of a simple tool of assessment for patients with epistaxis that could guide in subgrouping those with possible bleeding tendencies who may need further assessment. Methods Children who presented to a tertiary outpatient clinic with epistaxis o
International Archives of Otorhinolaryngology. Publicado em: 2022
-
3. Settlement of bored piles with expander body system in lateritic soils
Abstract The Expander Body pile (EB) is a combination of a cast-in-situ pile method with an inflated, pump-grouted tip. The EB system's pioneering conjunction with the conventional drilling pile technique has improved work load, foundation security, cost reductions and abrupt displacements in lateritic, porous, unsaturated soils. The aim of this article is t
REM, Int. Eng. J.. Publicado em: 2021-09
-
4. Evaluation of mortars produced with Baosteel slag short flow (BSSF) steel slag as fine aggregate
Abstract The objective was to evaluate the influence of Baosteel slag short flow (BSSF) steel slag, a byproduct of a Brazilian steel mill, as a fine aggregate on the properties of fresh state and on the compressive strength of mortars. The experimental work was to characterize the BSSF steel slag and to produce simple mortars (only cement) and mixed mortars
Cerâmica. Publicado em: 2021-03
-
5. Geological - geotechnical characterization of different lithotypes in an underground mine
Abstract A mineralogical, geological and geotechnical characterization of several rock types (phyllite, dolomite, breccia and marl) from an underground mine site aimed, among other things, to identify its mineral composition and to provide parameters to support the understanding of rock mass behavior. For this purpose, it was possible to perform laboratory a
REM, Int. Eng. J.. Publicado em: 2021-01
-
6. FEM-DEM simulation of Uniaxial Compressive Strength (UCS) laboratory tests
Abstract Finite/discrete element methods (FDEM) are hybrid numerical models that use algorithms to analyze the transition from continuous to discontinuous. This type of formulation allows modeling physical laboratory tests with greater proximity to reality. This article proposes to simulate the average behavior of a uniaxial compression test campaign. The te
REM, Int. Eng. J.. Publicado em: 2020-12
-
7. STUDY OF THERMAL EXPANSION AND COMPRESSION STRENGTH OF THREE WOOD SPECIES FROM PLANTATIONS
ABSTRACT The objective of this study was to evaluate the effect generated by a thermal treatment on the dimensional changes and compression behavior of three wood species from commercial plantations (Eucalyptus nitens, Tectona grandis and Gmelina arborea). To accomplish the goal, dilatometric and compression tests were performed in the three directions of wo
CERNE. Publicado em: 2020-06
-
8. Inflammatory segmental vitiligo during oral isotretinoin use: a casual association?,
ABSTRACT The objective of this study was to evaluate the effect generated by a thermal treatment on the dimensional changes and compression behavior of three wood species from commercial plantations (Eucalyptus nitens, Tectona grandis and Gmelina arborea). To accomplish the goal, dilatometric and compression tests were performed in the three directions of wo
An. Bras. Dermatol.. Publicado em: 2020-06
-
9. Geomechanical characterization of carbonates of the Sete Lagoas Formation (Bambuí Group)
Abstract The geomechanical properties of rock masses must be identified to assess their quality and employability; however, the methodologies may differ depending on the lithotype and analytical purposes. The present study aimed to estimate the not-well-known physical-mechanical properties of three types of carbonate rocks (calcarenite, calcilutite, and marb
REM, Int. Eng. J.. Publicado em: 2020-03
-
10. Análise da resistência de placas ósseas de acrílico fabricadas a laser quando submetidas a diferentes forças que agem sobre o foco de fratura
RESUMO Objetivou-se com este trabalho analisar a resistência de placas ósseas de acrílico, confeccionadas com cortadora a laser CO2, quando submetidas às forças que agem sobre o foco de fratura. Foram utilizados 40 fêmures de ovinos (Ovis aries) e confeccionadas 40 placas de acrílico, os quais foram avaliados em grupos: grupo OP - foram avaliados 20 o
Arq. Bras. Med. Vet. Zootec.. Publicado em: 13/12/2019
-
11. Hardening and Dynamic Recovery During Hot Compression Test of Copper Simulated as Viscoplastic Material
The Norton-Bailey equation was used to simulate by finite elements the hardening and dynamic recovery of copper during the hot compression tests. The constants of Norton-Bailey equation were determined from the Voce-Kocks model. The simulation assumes a Mortar Contact with Coulomb friction and axial symmetry. Numerical results were compared with experiments.
Mat. Res.. Publicado em: 05/12/2019
-
12. Avaliação do comportamento de estanqueidade à água de argamassas e hidrorrepelentes – Parte II
RESUMO Além da função estética, os revestimentos de fachada protegem as edificações da penetração de água e, consequentemente, diminuem a propensão ao surgimento de manifestações patológicas que levariam à degradação da superfície. Este trabalho apresenta os ensaios de avaliação do comportamento de estanqueidade à água de revestimentos a
Matéria (Rio J.). Publicado em: 25/11/2019