Combustion Pressure
Mostrando 1-12 de 72 artigos, teses e dissertações.
-
1. Halogen Determination in Polymeric Waste of Electrical and Electronic Equipment: Overcoming Limitations in Sample Preparation
Sample preparation of polymers for halogen determination requires special attention because they are difficult to bring into solution and due to the risk of analyte losses when using acid digestion. A method using microwave-induced combustion (MIC) was optimized for accurate determination of halogens in polymeric parts obtained in waste of electrical and ele
J. Braz. Chem. Soc.. Publicado em: 24/10/2019
-
2. Numerical Study on Response Characteristics of Solid Rocket Pintle Motor
ABSTRACT: Pintle technology is currently a versatile technology used in a solid rocket motor (SRM) to control the desired thrust by changing the nozzle throat area, while effectively controlling the chamber pressure at the same time. The sudden movement of the pintle can induce rapid changes in the flow field and the occurrence of pressure oscillations insid
J. Aerosp. Technol. Manag.. Publicado em: 26/08/2019
-
3. Studies on Heat Flux Imparted on Thermal Insulation Inside Rocket Motor Containing Double Base Propellant
ABSTRACT Thermal insulation inside the rocket motor experience severe pressure and temperature conditions. Experimental determination of heat flux imparted to thermal insulator inside the rocket motor during the static firing is a challenging task. This paper reports experimental determination of heat flux for double base propellant (DBP) in small rocket mot
J. Aerosp. Technol. Manag.. Publicado em: 10/07/2019
-
4. Síntese de óxidos mistos AMn2O4 (A=Co, Cu e Ni) preparados por autocombustão para controle de emissões de compostos orgânicos voláteis
RESUMO Os compostos orgânicos voláteis (COVs) são substâncias que possuem elevada pressão de vapor e baixa solubilidade em água e são reconhecidos por serem um dos maiores responsáveis pela poluição atmosférica, tanto por sua natureza tóxica quanto por serem os precursores do ozônio e do smog fotoquímico. O objetivo deste trabalho foi sintetiza
Matéria (Rio J.). Publicado em: 20/05/2019
-
5. SIMULAÇÃO DE COMBUSTÃO DO POLIBUTADIENO LÍQUIDO HIDROXILADO, PERCLORATO DE AMÔNIO E ALUMÍNIO EM FORMULAÇÕES DE PROPELENTE SÓLIDO COMPÓSITO
The present work presents combustion simulations of hydroxyl-terminated liquid polybutadiene loaded with ammonium perchlorate and aluminum, using Chemkin software and the “Plug Flow” type reactor. These materials are widely used in solid composite propellant formulations. Through this study, the effect of parameters of axial velocity, equivalence ratio,
Quím. Nova. Publicado em: 2019-02
-
6. Biodiesel Glycerides from the Soybean Ethylic Route Incomplete Conversion on the Diesel Engines Combustion Process
An evaluation was made to determine the effect of the glycerides presence resulting from the incomplete conversion of soybean biodiesel produced via alkaline catalysis and ethylic route on engine performance, and emissions in formulations containing 10 and 20% (m/m) of biodiesel used as additives in base diesel with low sulfur content and cetane ratings of 4
J. Braz. Chem. Soc.. Publicado em: 2017-12
-
7. Analysis of combustion efficiency in a pelletizing furnace
Abstract The objective of this research is to assess how much the improvement in the combustion reaction efficiency can reduce fuel consumption, maintaining the same thermal energy rate provided by the reaction in a pelletizing furnace. The furnace for pelletizing iron ore is a complex thermal machine, in terms of energy balance. It contains recirculation fa
REM, Int. Eng. J.. Publicado em: 2016-09
-
8. Experimentally Validated Combustion and Piston Fatigue Life Evaluation Procedures for the Bi-Fuel Engines, Using an Integral-Type Fatigue Criterion
Abstract A relatively complete procedure for high cycle fatigue life assessment of the engine components is outlined in the present paper. The piston is examined as a typical component of the engine. In this regard, combustion process and transient heat transfer simulations, determination of the instantaneous variations of the pressure and temperature in the
Lat. Am. j. solids struct.. Publicado em: 2016-06
-
9. THEORETICAL STUDY OF CO2:N2 ADSORPTION IN FAUJASITE IMPREGNATED WITH MONOETHANOLAMINE
Abstract Many efforts have been made to develop amine-based solid adsorbents for capture of CO2 by adsorption. Compared with the traditional process of absorption in aqueous solutions of amines, the adsorbents with amine immobilized in solids generally result in processes with lower capital and energy costs. The literature contains some experimental studies
Braz. J. Chem. Eng.. Publicado em: 2015-09
-
10. Combustion Modeling of Aluminum Incorporated in Low-Explosive Formulations such as Solid Propellants
ABSTRACT: Aluminum that is incorporated in an energetic material such as a propellant plays a significant role in the combustion process by means of stabilization with regard to the burning and generation of additional energy. The use of simulation softwares to model the combustion mechanism and kinetic parameters of the elementary reactions that compose the
J. Aerosp. Technol. Manag.. Publicado em: 2013-09
-
11. Large Eddy Simulation of Bluff Body Stabilized Turbulent Premixed Flame
ABSTRACT: A turbulent reacting flow in a channel with an obstacle was simulated computationally with large eddy simulation turbulence modeling and the Xi turbulent combustion model for premixed flame. The numerical model was implemented in the open source software OpenFoam. Both inert flow and reactive flow simulations were performed. In the inert flow, comp
J. Aerosp. Technol. Manag.. Publicado em: 2013-06
-
12. Estudos de processos avançados em geração termelétrica utilizando leitos fluidizados consumindo biomassa / Advanced studies on power generation processes based on fluidized beds consuming biomass
A study aiming maximizing the efficiency of an advanced combined power generation process has been developed. The process applies a pressurized fluidized bed boiler consuming sugar cane bagasse fed as slurry. The generated steam is diverted to a reheated Rankine cycle while the gas exiting the boiler is directed to a gas turbine process. Many assumptions hav
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 23/07/2012