Capacitive
Mostrando 13-24 de 84 artigos, teses e dissertações.
-
13. Pseudocapacitance Properties of Co3O4 Nanoparticles Synthesized Using a Modified Sol-Gel Method
This work reports the synthesization of nanoparticles cobalt oxide (Co3O4) with no secondary phase by a modified sol-gel method and its structural morphological and electrochemical characterizations. FTIR, XRD and Raman analysis showed the formation of spinel cobalt oxide with no secondary phase. TEM images revealed that an undefined morphology with average
Mat. Res.. Publicado em: 05/02/2018
-
14. A Compact UWB Bandpass Filter using Hybrid Fractal Shaped DGS
Abstract In this paper, a novel and compact ultra wideband (UWB) bandpass filter (BPF) based on fractal-shaped defected ground structure (DGS) is designed and developed. It is made of stepped impedance lines and a composite right/left handed-transmission line (CRLH-TL) constructed with capacitive gap in conductor strip and a hybrid fractal-shaped ring slot i
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2017-03
-
15. Electrochemical Behavior of Titanium Nitride Thin Films Deposited on Silicon by Plasma Discharge Technique in Cathodic Cage
Titanium nitride films were deposited on silicon by plasma discharge in cathodic cage with holes and without holes on the sides. Each film was deposited with a pressure of 253 Pa, treatment time of 2 h, and at diverse conditions of temperature and gas flow of N2 and H2. The electrochemical polarization and electrochemical impedance techniques were used to un
Mat. Res.. Publicado em: 22/08/2016
-
16. An Accurate Study on Capacitive Microphone with Circular Diaphragm Using a Higher Order Elasticity Theory
Abstract This study has been undertaken to investigate the mechanical behavior of the capacitive microphone with clamped circular diaphragm using modified couple stress theory in comparison to the classical one. Presence of the length scale parameter in modified couple stress theory provides the means to evaluate the size effect on the microphone mechanical
Lat. Am. j. solids struct.. Publicado em: 2016-04
-
17. ELETRODOS DE FTO MODIFICADOS POR ELETRODEPOSIÇÃO DIRETA DE OURO: PRODUÇÃO, CARACTERIZAÇÃO E APLICAÇÃO COMO SENSOR ELETROQUÍMICO
Chemically modified electrodes have been studied to obtain new and better electrochemical sensors. Transparent conductive oxides, such as fluorine-doped tin-oxide (FTO), shows electrical conductivity comparable to metals and are potential candidates for new sensors. In this work, FTO was modified by gold electrodeposition from chlorine-auric acid solution us
Quím. Nova. Publicado em: 2016-02
-
18. Analysis and Comparison of Sensors for Measurements of Partial Discharges in Hydrogenerator Stator Windings
Abstract In order to measure electrical signals produced by partial discharges in hydrogenerators stator windings, capacitive couplers are regularly used. They are electrically connected to the windings and therefore, require undesired insulation intrusion. For avoiding such an intrusion, a microstrip directional coupler is used, which is experimentally and
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2015-12
-
19. Anionic Aliphatic Polyesteramide Copolymers: Evaluation of Dielectric Properties
This study looks at the effects on the dielectric behavior as result of the incorporation of ester sequences along the nylon 6 chains. The aliphatic polyesteramide copolymers and nylon 6 homopolymer were synthesized via anionic ring-opening copolymerization using the rotational molding technique by varying the ratio of the ε-caprolactam (CLA) and ε-caprola
J. Braz. Chem. Soc.. Publicado em: 2015-02
-
20. Cathodic cage plasma nitriding of austenitic stainless steel (AISI 316): influence of the working pressure on the nitrided layers properties
In this work, the influence of working pressure on the characteristics of the layers produced by the nitriding treatment on the AISI 316 austenitic stainless steel surface using the Cathodic Cage Plasma Nitriding technique (CCPN) is assessed. The treatments were carried out at a temperature of 723 K for 5 hours under working pressures of 120, 250 and 500 Pa.
Mat. Res.. Publicado em: 06/12/2013
-
21. Filtros digitais por transformadas de Fourier aplicados em eletroquímica
The electrochemical properties of micro and nano-electrodes are widely investigated due to their low faradaic and capacitive currents, leading to a new generation of smart and implantable devices. However, the current signals obtained in low-dimensional devices are strongly influenced by noise sources. In this paper, we show the evaluation of filters based o
Quím. Nova. Publicado em: 2013
-
22. Desenvolvimento de um pedal de acelerador capacitivo para aplicações automotivas / Development of an capacitive accelerator pedal to automotive aplications
O conceito drive by wire, resultado da evolução tecnológica, introduziu a comunicação entre sensores e atuadores através de sinais elétricos, substituindo acoplamentos mecânicos como cabos flexíveis e varetas de aço. Destaca-se neste conceito o mecanismo de aceleração de um veículo, no qual a posição angular é convertida em um sinal elétrico
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 29/07/2011
-
23. Self-Tuning Multimodal Piezoelectric Shunt Damping
Piezoelectric shunt damping is a well known structural vibration control technique that consists in connecting an electrical circuit to a piezoelectric transducer attached to the structure. In the case of a resonant shunt, the network consisting of an inductor-resistor network when combined with the capacitive nature of the piezoelectric transducer impedance
Journal of the Brazilian Society of Mechanical Sciences and Engineering. Publicado em: 2011-12
-
24. Otimização de largura de banda de antena de microfita
Neste trabalho é realizada a otimização de antena de microfita banda larga usando o método de Diferenças Finitas no Domínio do Tempo (FDTD) e software comercial de onda completa. Inicialmente é feita uma introdução sobre o assunto, abordando aspectos de comunicações e de antenas de microfita, além de se fazer uma revisão bibliográfica e resumir
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 2011