Study on influence of the PTA-P welding process parameters on corrosion behavior of Inconel 625 coatings

AUTOR(ES)

Santos, Aureliano Xavier dos

FONTE

Matéria (Rio J.)

DATA DE PUBLICAÇÃO

20/05/2019

RESUMO

ABSTRACT In the present work, PTA welding process was used to investigate the influence of welding parameters on the dilution, microhardness and corrosion resistance of Inconel 625 alloy coatings on the API 5L X70 grade steel. The electrochemical impedance spectroscopy (EIS) and linear potentiodynamic polarization (LPP) measurements were used to study the protection properties of the deposited layer when immersed in a 3.5% NaCl solution. The results of EIS and LPP have shown that the corrosion resistance results were more satisfactory for coatings with higher dilution index. The results also showed that the dilution values D (%)varied from 15.33% to 4.39% at the maximum (18.99 kJ/cm) and the minimum (8.34 kJ/cm) welding energy levels. The most relevant dilution value obtained was 4.39%.

Documentos Relacionados

• Evaluation of the Influence of Surface Finishing on the Corrosion Resistance of HVOF Applied Inconel 625 Coatings on Steel
• Development of a Powder-feed Device and Procedures for the Application of an Experimental Alloy in Overhead PTA-P Welding
• Processo PTA-P - uma revisão da literatura como base para inovações. Parte 1 de 2: elementos construtivos
• Fracture Behavior and Fatigue Performance of Inconel 625
• Performance of the INCONEL 625 alloy weld overlay obtained by FCAW process