Structural analyses of reinforced tubular T-joints

AUTOR(ES)
FONTE

Rem: Rev. Esc. Minas

DATA DE PUBLICAÇÃO

2016-03

RESUMO

Abstract The use of rolled hollow sections has been substantially boosted mainly due to the advantages associated with structural behavior and aesthetics, leading to an intense use in Europe, Southeast Asia, North America, Australia, and now, in Brazil due to the wider supply of these profiles. Therefore, it is important to investigate the structural behavior in order to provide an adequate structural design for the civil engineering community. Thus, this paper presents a parametric analysis of a reinforced T-joint focused on NBR 16239 provisions. Two types of reinforcement plates: Collar and Double were investigated. A wide set of numerical models has been defined varying the thickness of the reinforcing plate, chord and brace members and axial loads applied in the brace. The numerical models have been developed using ANSYS 12.0 software considering both geometrical and material non-linearity. Concerning the results, there was a slight gain of resistance when a double plate reinforcement was used, mainly for small displacement, due to large stiffness provided and a linear response up to the serviceability limit. In addition, Von Mises stress distribution confirmed the type A failure with chord yielding beginning at the upper chord surface. Comparing the numerical results with NBR 16239 provisions, an excessive conservatism was noted for this code. In fact, the Brazilian code only takes into account the reinforcement thickness in joint resistance. However, when the results provided by the new proposal where both thicknesses (chord and reinforcement) are considered, a more realistic assessment of the joint capacity is obtained.

Documentos Relacionados