Simulations of the Atmospheric Boundary Layer in a Wind Tunnel with Short Test Section

AUTOR(ES)

Pires, Luciana Bassi Marinho, Paula, Igor Braga de, Fisch, Gilberto, Gielow, Ralf, Girardi, Roberto da Mota

FONTE

J. Aerosp. Technol. Manag.

DATA DE PUBLICAÇÃO

2013-09

RESUMO

ABSTRACT: This article presents a study of three different passive devices (spires, screens, and a carpet) separately and in various combinations, to simulate the atmospheric boundary layer (ABL) in a wind tunnel with a short test chamber (465×465x1200mm). The influence of distances between these devices on the formation of the ABL is established, and optimization of variation of thicknesses of the screens (thin, medium, and coarse) on pressure loss is explored. The results obtained in this work gave support for the analysis of the atmospheric flow and turbulence at Alcantara Launching Center (ALC) in order to launch Brazilian space vehicles under safe conditions. The results show that the “spires” and the thin screen are the devices that require the least area to form an ABL in a test chamber. The physical proximity of two devices (the spires and the medium screen) also influences the size of the ABL formed, which varies from 180 to 200 mm. The power law exponent ranged from 0.12 up to 0.14 after the insertion of a carpet.

Documentos Relacionados

• Wind tunnel simulation of atmospheric boundary layer flows
• Studies using wind tunnel to simulate the Atmospheric Boundary Layer at the Alcântara Space Center
• Wind Tunnel Simulation of the Atmospheric Boundary Layer for Studying the Wind Pattern at Centro de Lançamento de Alcântara
• Numerical and experimental evaluation of the thermally stratified atmospheric boundary layer in wind tunnels
• Wind tunnel test for vortex-induced vibration of vehicle-bridge system section model