Preparation and characterization of conducting polymer electrodes on reticulated vitreous carbon (RVC) for application in secondary batteries. / Preparação e caracterização de eletrodos de polímeros condutores sobre carbono vítreo reticulado (RVC) para a aplicação em baterias secundárias.

AUTOR(ES)

Carla Dalmolin

DATA DE PUBLICAÇÃO

2006

RESUMO

The general purpose of this work is the optimization of the conducting polymer deposition on RVC and the use of these electrodes in an allpolymeric ion-lithium battery, which means an anode and a cathode made of conducting polymers. Several steps were done in order to attain this purpose: i) a previous study on the effect of different pre-treatments on the RVC surface; ii) the optimization of the deposition (chemical or electrochemical) procedures of conducting polymers on RVC; iii) the investigation of the influence of different kinds of deposition on the properties of the conducting polymers; iv) the study about the effect of different dopants on the electrochemical and morphological properties of the polymers; and v) the verification of the electrode performance as anode or cathode in an ion-lithium battery. The results lead to the conclusion that the ohmic drop effects and low current penetration, a characteristic of the tridimensional RVC electrodes, can be minimized by using thinner electrodes, which is crucial specially for conducting polymer films obtained by electropolymerization. The high surface area of these materials influenced positively on the electrochemical behavior of the electrodes, leading to high-specific capacity electrodes when compared to similar bidimensional electrodes. However, to enable the investigation of these electrodes by Electrochemical Impedance Spectroscopy, the proposition of a new equivalent electrical circuit was done considering two different electrochemical environments (at the inner and outer substrate surfaces). Chargedischarge tests for batteries using RVC/polymer electrodes as the cathodic material showed similar or even higher specific capacities than the ones found in the literature. It is believed that the substrates high surface area is the responsible for these findings, since it facilitates the redox reactions in the polymers.

ASSUNTO(S)

carbono vítreo reticulado quimica eletroquímica polímeros condutores baterias de íons-lítio

Documentos Relacionados

• Preparação e caracterização de compósitos de polipirrol (LiMn2O2)/ fibra de carbono para catodos em baterias secundárias.
• Obtenção e caracterização de carbono vítreo reticulado
• "Preparação e aplicação de eletrodos de pasta de carbono modificados com ditiocarbamatos para análise de fármacos"
• Development and characterization of modified electrodes with conducting polymer materials for electroanalytical detection of pesticides.
• Eletrossíntese, caracterização e testes de compósitos de polipirrol e poli(DMcT) sobre fibra de carbono como catodos de baterias secundárias e eletrodos de supercapacitores