Laser sintering and characterization of the compounds Bi4Ti3O12 and Bi4Ge3O12 / "Sinterização a laser e caracterização física dos compostos Bi4Ti3O12 e Bi4Ge3O12"

AUTOR(ES)
DATA DE PUBLICAÇÃO

2003

RESUMO

The goals of this work were the implantation and optimization of the laser sintering technique for ceramic bodies, the kinetic study of the process and the evaluation of the physical properties of the laser sintered compounds Bi4Ti3O12 and Bi4Ge3O12, compared to ceramics sintered in conventional furnace. The choice of the materials was based on their potential applications: Bi4Ge3O12 as scintillator device and Bi4Ti3O12 as an electronic ceramic. Laser sintering showed to be efficient for these materials, producing ceramics with density higher than 98 % and small grain sizes. The combination of pre-heating with a gradual rising of the laser power prevented excessive temperature gradient and heating rate, and reduced considerably the incidence of cracks and pores in the ceramics. The kinetic study of the laser sintering revealed lower activation energies than that observed in the conventional processing, except for BIT ceramics during the final stage of sintering. The results suggest that the laser irradiation anticipates the stages of the sintering process. The physical characterization of BIT was done through impedance spectroscopy and ferroelectric hysteresis measurements. Compared to the conventional sample, this material presented bulk electrical conductivity 3 times smaller, higher dielectric permittivity above 300 °C, comparable dielectric loss, the same coercive field and 35 % higher remanent polarization. The physical characterization of BGO was done through optical absorption, radioluminescence and thermoluminescence measurements. The results showed that the transparency of the laser sintered BGO ceramic was 50 % higher than the transparency of the conventional BGO ceramic, the density of structural defects is 2 times lower, the radiation damage levels are comparable and the overall scintillating efficiency is slightly higher. The obtained results were interpreted on the basis of the time scale of the laser sintering, which affects the formation and distribution of defects during the process, and results in a particular microstructure.

ASSUNTO(S)

ferroelétricos termoluminescência espectroscopia de impedância laser cintilators radioluminescência ceramics impedance spectroscopy laser cintiladores ferroelectrics radioluminescence thermoluminescence cerâmicas

Documentos Relacionados