KRAFT LIGNIN AS AN ADDITIVE IN PINE AND EUCALYPTUS PARTICLE COMPOSITION FOR BRIQUETTE PRODUCTION

AUTOR(ES)
FONTE

Rev. Árvore

DATA DE PUBLICAÇÃO

13/06/2019

RESUMO

RESUMO O objetivo deste trabalho foi avaliar as propriedades de briquetes produzidos com diferentes proporções de partículas de madeira de pinus e eucalipto, bem como caracterizar o potencial de uso da lignina kraft como aditivo na composição destes briquetes para a geração de energia. Os tratamentos diferenciaram-se na proporção de mistura de partículas pinus e eucalipto (0, 25, 50, 75 e 100%) e na proporção de lignina kraft (0, 2, 4, 6, 8, 10 e 12%). As propriedades dos briquetes foram avaliadas a partir da densidade aparente, densidade energética, resistência à carga de ruptura e do poder calorífico inferior (PCI). Os resultados indicaram um aumento de densidade aparente conforme aumentou a proporção de eucalipto e de lignina nos briquetes. A composição das partículas teve maior influência no aumento da densidade energética em relação à adição de lignina kraft, sendo mais expressiva em briquetes feitos com maior proporção de eucalipto. Foi observado ainda que a adição de lignina proporcionou maior resistência à carga de ruptura, e que existiu um valor específico em que foi mais elevado (7% ou 11% de lignina, dependendo da proporção de partículas). Além disso, os briquetes feitos com 100% de pinus alcançaram maior carga de ruptura. De modo geral, a lignina kraft apresentou um bom potencial para ser utilizada como aditivo em briquetes, na qual contribuiu para melhorar as suas propriedades energéticas e mecânica.ABSTRACT The objective of this study was to evaluate the properties of briquettes produced with different proportions of pine and eucalyptus wood, as well as to characterize the potential of kraft lignin as an additive in the composition of briquettes for energy generation. The treatments differed from one another in the pine and eucalyptus wood particle ratios (0, 25, 50, 75 and 100%), as well as for the kraft lignin content (0, 2, 4, 6, 8, 10, and 12%). The biomasses were characterized by their physical and chemical properties, and briquette properties were evaluated according to apparent density, lower calorific value (LCV), energy density, and maximum burst load. The results showed an increase in the apparent density as the proportion of lignin and eucalyptus in the briquettes increased. The particle composition of the briquettes had a higher influence on the energy density increase compared to the addition of kraft lignin, being more significant in briquettes produced with higher proportions of eucalyptus. It was also observed that the addition of lignin increased the resistance to the rupture load, and that there was a specific value at which this resistance was higher (at 7% or 11% of lignin, depending on the proportion of particles). Additionally, the briquettes made with 100% pine achieved greater mechanical resistance. In general, kraft lignin presented good potential for use as a briquette additive, contributing to improved energy and mechanical properties.

Documentos Relacionados