Influence of implant-abutment angulations and crown material on stress distribution on central incisor: a 3D FEA
El-Anwar, Mohamed I., AL-Azrag, Khairy E., Ghazy, Mohamed H., Dawood, Lamia E.
Braz. J. Oral Sci.
DATA DE PUBLICAÇÃO
Abstract Aim: To investigate the effect of implant-abutment angulation and crown material on stress distribution of central incisors. Finite element method was used to simulate the clinical situation of a maxillary right central incisor restored by two different implant-abutment angulations, 15° and 25°, using two different crown materials (IPS E-Max CAD and zirconia). Methods: Two 3D finite element models were specially prepared for this research simulating the abutment angulations. Commercial engineering CAD/CAM package was used to model crown, implant abutment complex and bone (cortical and spongy) in 3D. Linear static analysis was performed by applying a 178 N oblique load. The obtained results were compared with former experimental results. Results: Implant Von Mises stress level was negligibly changed with increasing abutment angulation. The abutment with higher angulation is mechanically weaker and expected to fail at lower loading in comparison with the steeper one. Similarly, screw used with abutment angulation of 25° will fail at lower (about one-third) load value the failure load of similar screw used with abutment angulated by 15°. Conclusions: Bone (cortical and spongy) is insensitive to crown material. Increasing abutment angulation from 15° to 25°, increases stress on cortical bone by about 20% and reduces it by about 12% on spongy bone. Crown fracture resistance is dramatically reduced by increasing abutment angulation. Zirconia crown showed better performance than E-Max one.
- Comparison of methods to evaluate implant-abutment interface
- Preload loss and bacterial penetration on different implant-abutment connection systems
- Resistance of three implant-abutment interfaces to fatigue testing
- A 3-D Finite Element Study of the Influence of Crown-Implant Ratio on Stress Distribution
- Effects of different torque levels on the implant-abutment interface in a conical internal connection