Entropy-driven instability and rupture of fluid membranes.

AUTOR(ES)

Shillcock, J C

RESUMO

A computer simulation is used to investigate hole formation in a model membrane. The model parameters are the stress applied to the membrane, and the edge energy per unit length along the hole boundary (edge tension). Even at zero stress, the membrane has an entropically driven instability against hole formation. Within the model, the minimum edge tension required for the stability of a typical biological membrane is in the region of 1 x 10(-11) J/m, which is similar to the edge tension obtained in many measurements of biomembranes. At the zero-stress instability threshold, the hole shape is the same as a self-avoiding ring, but under compression, the hole shape assumes a branched polymer form. In the presence of large holes at zero stress, the membrane itself behaves like a branched polymer. The boundaries of the phase diagram for membrane stability are obtained, and general features of the rate of membrane rupture under stress are investigated. A model in which the entropy of hole formation is proportional to the hole perimeter is used to interpret the simulation results at small stress near the instability threshold.

Documentos Relacionados

• Carbon monoxide-driven electron transport in Clostridium thermoautotrophicum membranes.
• Cholesterol-induced fluid-phase immiscibility in membranes.
• Renormalization of the tension and area expansion modulus in fluid membranes.
• Self-organization of the fluid mosaic of charged channel proteins in membranes.
• Cryo-transmission electron microscopy of a superstructure of fluid dioleoylphosphatidylcholine (DOPC) membranes.