Effect of the heat curing on strength development of self-compacting mortars containing calcined silt of dams and Ground Brick Waste

AUTOR(ES)

Safi, B., Ghernouti, Y., Rabehi, B., Aboutaleb, D.

FONTE

Mat. Res.

DATA DE PUBLICAÇÃO

18/06/2013

RESUMO

The strength development of self-compacting mortars (SCM) containing calcined silt (CS) and ground brick waste (GWB) was investigated. The variables are the nature of addition (CS and GWB) in the binder and the heat curing at different temperatures (20 ºC and 60 ºC) at 7 and 14 days of curing. Two temperatures 20 and 60 ºC were applied to samples with intermediate levels (depending on the drying method applied to precast) for 18 hours in total. In this study, a Portland cement (CEMII), Calcined silt (750 ºC for 5 hours), ground waste brick, were used in the binders of SCM. The results show that the compressive strength to 14 days of mortars, increases with annealing (60 ºC) compared to that measured at 20 ºC. Also, values of compressive strength of mortars at 14 days that are close to those obtained without 28 days curing treatment. Indeed, a strength gain of about 20.5% and 27.3% was obtained respectively for the SCM with GWB and the SCM with CS. However, a small change in mass recorded for both types of mortars.

Documentos Relacionados

• Experimental Investigation on Self-Compacting Self-Curing Concrete Incorporated with the Light Weight Aggregates
• Impact of vibrations on the final characteristics of normal and self-compacting concrete
• Assessing flow response of self-compacting mortar by Taguchi method and ANOVA interaction
• Study of the compressive and tensile strenghts of self-compacting concrete with sugarcane bagasse ash
• A study of packing parameters that influence the fresh properties of self-compacting concrete