Effect of Pesticide Addition Sequence on the Preparation of Phytosanitary Spray Solutions

AUTOR(ES)
FONTE

Planta daninha

DATA DE PUBLICAÇÃO

09/09/2019

RESUMO

RESUMO: A adição de adjuvantes às caldas herbicidas visa preservar ou aumentar o efeito biológico do tratamento, porém é comumente realizada sem conhecimento das interações físico-químicas entre os produtos. Assim, objetivou-se neste trabalho avaliar os efeitos sobre a tensão superficial e o ângulo de contato decorrentes de diferentes sequências de adição do herbicida aminopiralide + fluroxipir e adjuvantes no preparo de caldas fitossanitárias. Foram realizados dois experimentos, com a dosagem de 1 e 2 L ha-1 do herbicida, associados aos adjuvantes óleo mineral (OM), copolímero de poliéter e silicone (SIL), mistura de fosfatidicolina e ácido propiônico (LEC), todos na proporção de 0,3% v v-1. A taxa de aplicação considerada foi de 150 L ha-1. Mediu-se a tensão superficial pelo método da gota pendente. O ângulo de contato foi medido nas superfícies adaxial e abaxial de folhas da planta daninha de pastagens Senna obtusifolia e em parafilme. Verificou-se que a ordem de preparo não alterou o ângulo de contato em nenhuma das superfícies analisadas na dosagem de 1 L ha-1 do herbicida. Para a dosagem de 2 L ha-1, os adjuvantes SIL e LEC apresentaram maior espalhamento quando adicionados previamente ao herbicida. O OM resultou em maior espalhamento quando adicionado após o herbicida, com maior cobertura da superfície. Portanto, a sequência de preparo das caldas fitossanitárias influencia no espalhamento destas sobre os alvos.ABSTRACT: The addition of adjuvants to herbicide solutions is aimed at preserving or enhancing the biological effect of treatment. However, it is commonly performed without knowledge of the physicochemical interactions between products. This study aimed to assess the effects of different addition sequences of the herbicide aminopyralid + fluroxypyr and adjuvants in the preparation of phytosanitary spray solutions on the surface tension and contact angle. Two experiments were carried out with herbicide doses of 1 and 2 L ha-1 associated with the adjuvants mineral oil (MO), silicone-polyether copolymer (SIL), and a mixture of phosphatidylcholine (lectin) and propionic acid (LEC), all at a proportion of 0.3% v v-1. The application rate was 150 L ha-1. Surface tension was measured by the pendant droplet method. Contact angle was measured on the adaxial and abaxial surfaces of leaves of the pasture weed Senna obtusifolia and parafilm. Preparation sequence did not change the contact angle on any of the analyzed surfaces at a dose of 1 L ha-1 of herbicide. For the dose of 2 L ha-1, the adjuvants SIL and LEC showed a higher spreading when previously added to the herbicide. MO resulted in a higher spreading when added after the herbicide, with higher surface coverage. Therefore, the preparation sequence influences the dispersion of phytosanitary spray solutions on targets.

Documentos Relacionados