Efeito do metal de adição na resistência ao desgaste por deslizamento de um aço estrutural soldado por GMAW

AUTOR(ES)
FONTE

Matéria (Rio J.)

DATA DE PUBLICAÇÃO

16/09/2019

RESUMO

RESUMO O objetivo do presente trabalho foi avaliar o efeito do metal de adição na soldagem, e das microestruturas resultantes, na resistência ao desgaste de juntas soldadas de um aço estrutural ASTM A242, que possui resistência à corrosão atmosférica e é utilizado na fabricação de vagões destinados ao transporte de minério. As amostras foram soldadas através do processo GMAW (Gas Metal Arc Welding), utilizando dois metais de adição que apresentam resistências mecânicas diferentes, AWS ER70S-6 e AWS ER80S-G. A resistência ao desgaste das amostras foi avaliada através de ensaios de microdesgaste por deslizamento linear recíproco, a seco e em uma solução contendo 0,05M NaCl, em três regiões da junta soldada: metal base (MB), metal de solda (MS) e zona afetada pelo calor de grãos grosseiros (ZAC-GG). Após a soldagem, foi observado um aumento nos valores médios de durezas do MS e da ZAC em relação à dureza inicial do metal base. Os resultados dos ensaios de microdesgaste mostraram que o MB apresentou a menor resistência ao desgaste, possivelmente devido à sua microestrutura, que facilitou o desgaste por deformação plástica. A ZAC-GG apresentou a maior resistência ao desgaste entre as três regiões analisadas. Comparando os ensaios realizados nas condições a seco e em solução foi observada uma redução nos valores de coeficiente de atrito quando adicionada uma solução ao sistema, e uma perda de volume das trilhas mais acentuada. Observou-se que a utilização do metal de adição de menor resistência mecânica produziu juntas soldadas com resistência ao desgaste comparável às juntas obtidas com o arame de maior resistência.ABSTRACT The aim of the present work was to evaluate the effect of the filler material in the welding and its resulting microstructures on the wear resistance of welded joints of a structural weathering steel ASTM A242 used in wagons for mining. The samples were welded using the GMAW (Gas Metal Arc Welding) process using two filler materials which have different mechanical strength, AWS ER70S-6 and AWS ER80S-G. The wear resistance of the samples was evaluated using a linearly reciprocating sliding microwear test, dry and in a solution containing 0.05M NaCl, in three regions of the welded joint: base metal (BM), weld metal (WM) and coarse grained heat affected zone (CGHAZ).After welding, it was observed an increase in the mean hardness values of the MS and ZAC in comparison to the initial hardness of base metal with the use of both filler metals, and the hardness values in each of these regions were similar. The results of the microwear tests showed that BM presented the lowest wear resistance, possibly due to its microstructure, which facilitated wear by plastic deformation. The CGHAZ showed the highest wear resistance. Comparing the tests carried out under the dry and in solution conditions, a reduction in the coefficient of friction was observed when the solution was added to the system, and the volume loss of the tracks was more pronounced. It was observed that the use of the lower mechanical strength filler material produced welded joints with wear resistance comparable to the joints obtained with the higher strength filler material.

Documentos Relacionados