Efeito de diferentes soluções irrigadoras na microdureza superficial Knoop de dentes artificiais

AUTOR(ES)
FONTE

Rev. odontol. UNESP

DATA DE PUBLICAÇÃO

24/10/2019

RESUMO

Resumo Introdução Dentes artificiais têm sido empregados para a prática de ensino pré-clínico. Porém, não se sabe o comportamento dos mesmos frente aos diferentes procedimentos realizados durante um tratamento endodôntico simulado. Objetivo Avaliar a microdureza de réplicas de dentes humanos, frente a diferentes soluções irrigadoras. Material e método Quarenta e cinco incisivos centrais superiores artificiais de três marcas comerciais nacionais (dentes “A”, “B” e “C”) e 15 incisivos humanos foram utilizados. As amostras foram seccionadas a 5 mm do ápice dentário. Os fragmentos radiculares foram fixados em resina para posterior teste de microdureza. Os ensaios da microdureza Knoop foram realizados em dois momentos: momento 1 - microdureza inicial; momento 2 - microdureza final, que foi feita após o uso das soluções irrigadoras (Cloreto de Sódio a 0,9%, Hipoclorito de Sódio a 2,5% e Gluconato de Clorexidina a 2%). As endentações deixadas na superfície da amostra foram mensuradas. O valor obtido para microdureza de cada amostra foi feita com base na média de três endentações. Para análise estatística, foram utilizados os testes ANOVA e Teste t pareado, com nível de significância de 5%. Resultado Os dentes artificiais “A” e “C” apresentaram valores inferiores de microdureza quando comparados ao dente humano (P = 0,05). Não houve diferença estatística entre os dentes artificiais “B” e o dente humano (P = 0,2428). Quanto ao uso das diferentes soluções irrigadoras, também não houve diferença na microdureza das peças dentárias. Conclusão Embora a solução irrigadora não tenha influenciado a microdureza, os dentes artificiais apresentaram valores de dureza inferiores aos do dente humano.Abstract Introduction Artificial teeth have been used for preclinical teaching practice. However, the behavior of the same is not known in relation to the different procedures performed during a simulated endodontic treatment. Objective To evaluate the microhardness of replicates of human teeth, in front of different irrigating solutions. Material and method Forty-five artificial upper central incisors of three national trade marks (teeth “A”, “B” and “C”) and fifteen human incisors were used. Samples were sectioned 5 mm from the apex. The root fragments were fixed in resin for later microhardness test. The Knoop microhardness tests were performed in two moments: moment 1 - initial microhardness; moment 2 - final microhardness, which was done after the use of the irrigating solutions (0.9% sodium chloride, 2.5% sodium hypochlorite and 2% chlorhexidine gluconate). The indentations left on the sample surface were measured. The obtained value for microhardness of each sample was made based on the average of three indentations. ANOVA and Paired t-test were used for statistical analysis. Significance level of 5%. Result Artificial teeth “A” and “C” presented lower values of microhardness when compared to human teeth (P = 0.05). There was no statistical difference between the artificial teeth “B” for the human (P = 0.2428). Regarding the use of different irrigation solutions, there was also no difference in the microhardness of dental pieces. Conclusion Although the irrigating solution did not influence the microhardness, the artificial teeth presented values of hardness inferior to the human tooth.

Documentos Relacionados