Efeito da Taxa de Resfriamento na Liga Ni80Cu20 via Dinâmica Molecular

AUTOR(ES)
FONTE

Matéria (Rio J.)

DATA DE PUBLICAÇÃO

20/05/2019

RESUMO

RESUMO A simulação em Dinâmica Molecular (MD) é uma poderosa ferramenta para estudo de ligas amorfas nanométricas. Neste artigo, a MD foi empregada para o estudo da liga Ni80Cu20. As simulações foram realizadas com o código livre LAMMPS, em um sistema contendo 2.000 átomos com interação atômica dada pelo potencial de Finnis-Sinclair (EAM-FS). O aquecimento foi realizado à taxa de 2 K/ps, entretanto, no resfriamento foram utilizadas as taxas de 40, 10, 4, 3, 2 e 1 K/ps, com a finalidade de se observar a evolução estrutural da liga. Taxas superiores a 3 K/ps conduzem à formação de estrutura amorfa. Por outro lado, taxas inferiores a esta permitem ao sistema formar uma estrutura cristalina Cúbica de Face Centrada (CFC). A estrutura da liga foi analisada empregando-se Funções de Distribuição Radial (RDF), os poliedros de Voronoi, e Common Neighbor Analysis (CNA). Além disto, foram realizados estudos de tratamento térmico tanto em modo dinâmico à taxa de resfriamento de 40 K/ps como isotérmico com a finalidade de observar a cristalização da liga amorfa. A curva tensão vs deformação indica que a presença de 20 % de nanocristais eleva a resistência mecânica sem afetar o módulo elástico. Com esta fração, que se forma por efeito do tratamento térmico, o limite de resistência é aumentado em mais de 30 %.ABSTRACT Molecular Dynamics (MD) is a powerful tool for the study of nanometric amorphous alloys. In the present work, MD was used to investigate the Ni80Cu20 alloy. The simulations were performed by using the free code LAMMPS, for a system containing 2,000 atoms. The atomic interaction was governed by Finnis-Sinclair (EAM-FS) potential. The heating was controlled by a rate 2 K/ps, however, the cooling stage used the following rates 40, 10, 4, 3, 2 and 1 K/ps, in order to observe the structural evolution of the alloy. Rates higher than 3 K/ps produce an amorphous structure. On the other hand, lower rates allow the formation of Cubic Face Centered (CFC) crystals. The alloy structure was analyzed by Radial Distribution Function (RDF), Voronoi polyhedrons, and Common Neighbor Analysis (CNA). Moreover, studies on the heat treatment with cooling rate at 40 K/ps as well as isothermal condition were performed to know the crystallization process of glassy alloy. The stress-strain curve indicates the presence of 20 % of nanocrystal increases the mechanical resistance without jeopardizing the elastic modulus. This fraction, resulting of heat treatment, increases the ultimate tensile strength at least 30 %.

Documentos Relacionados