Avaliação térmica, física e mecânica de blocos de concreto com poliestireno expandido reciclado

AUTOR(ES)
FONTE

Ambient. constr.

DATA DE PUBLICAÇÃO

03/10/2019

RESUMO

Resumo A presente pesquisa produziu blocos de concretos com substituição parcial do agregado graúdo comumente utilizado por poliestireno expandido reciclado. Para tanto, uma dosagem experimentalé proposta a partir da associação do modelo de empacotamento compressível com a metodologia adaptada de Tango, publicada em 1994, produzindo-se quatro tipos de blocos (um referencial sem substituição e três com substituição volumétrica de 5%, 10% e 15% do agregado pelo poliestireno expandido), com fator a/c igual a 0,5. As características físicas e mecânicas foram obtidas em conformidade com a NBR 12118:2013, identificando-se que os blocos referenciais e com 5% de substituição poderiam ser empregados para fins estruturais, enquanto aqueles com 10% e 15% de substituição não alcançaram a resistência mínima estabelecida pela NBR 6136:2016. A análise do desempenho térmico adotou procedimentos de cálculo da NBR 15220-2:2005, verificando-se os limites estabelecidos pela NBR 15575-4:2013. O conforto térmico proporcionado pelos blocos referenciais e com 15% de substituição, em protótipos de alvenaria, apresentaram resultados semelhantes para temperaturas internas durante o período observado. Contudo, no horário de pico da temperatura ambiente, verificaram-se maiores atrasos e inércia térmica na alvenaria com poliestireno reciclado.Abstract The research project produced concrete blocks with partial replacement of traditional coarse aggregate by recycled expanded polystyrene. Hence, an experimental dosage was proposed, associating the Compressible Packaging Model with Tango´s adapted methodology, published in 1994, to produce four types of blocks (one reference, without substitution, and three with content ratios of 5, 10 and 15% of partial volumetric replacement of coarse aggregate by expanded polystyrene), with a w/c ratio of 0,5. Tests were performed to check the physical and mechanical characteristics of the blocks, following NBR 12118:2013, demonstrating that the reference block and the one with 5% coarse aggregate partial replacement could be used for structural applications, while the blocks with 10 and 15% partial replacement did not meet the NBR 6136:2016 standard for minimum compressive strength. The analysis of the thermal performance of the blocks was done using the calculation procedures of NBR 15220-2:2005, verifying the limits established by NBR 15575-4:2013. The thermal comfort provided by the reference blocks and the blocks with 15% replacement in the masonry prototypes presented similar internal temperature results during the observed period. However, at times when the highest environment temperatures were recorded, the masonry with recycled polystyrene presented maximum delay and thermal inertia.

Documentos Relacionados