Avaliação do grau de orientação de fibras de aço induzida na moldagem de elementos planos com concreto autoadensável

AUTOR(ES)
FONTE

Matéria (Rio J.)

DATA DE PUBLICAÇÃO

10/06/2019

RESUMO

RESUMO O uso de concreto autoadensável (CAA) aliado ao concreto reforçado com fibras (CRF) tem sido objeto de várias pesquisas recentes. A combinação da fluidez do CAA com o uso de fibras aumenta a probabilidade de que, no processo de lançamento, seja possível causar orientação preferencial nas fibras, inclusive em elementos planos. Isto pode ser benéfico ou prejudicial ao desempenho estrutural, uma vez que a capacidade resistente pós-fissuração do CRF depende fortemente da disposição e orientação das fibras. Devido a isso, é necessário o desenvolvimento de metodologia que possibilite avaliar esta condição. O uso de ensaios especiais, como o indutivo, pode ser uma ferramenta de controle que auxilie na compreensão da influência das condições de moldagem na orientação das fibras. No entanto, não há muitas pesquisas voltadas à parametrização desta condição em elementos planos. Este estudo traz como objetivo a demonstração da efetividade de utilização do ensaio indutivo em testemunhos cúbicos extraídos de uma placa moldada com concreto autoadensável reforçado com fibras de aço. Como resultado, o ensaio indutivo permitiu medir a variação na concentração de fibras em cada testemunho e, através da orientação de fibras medida em cada cubo, traçar linhas de fluxo que apontem a influência da moldagem na orientação preferencial das fibras.Abstract The use of self-compacting concrete (SCC) combined with fiber reinforced concrete (FRC) has been the subject of several recent studies. The combination of the fluidity of the SCC with the use of fiber increases the possibility that, during the casting process, there is preferred orientation of the fibers, even in the case of slab elements. This could provoke an enhancement or a loss in structural performance, once the post cracking strength of FRC relies on the positioning and orientation of the fibers. Because of this, the development of a methodology is needed in order to allow the assessment of this condition. The use of special test methods, as the inductive test, may be a useful tool to help to understand the influence of the casting conditions in fiber orientation. However, there are not many studies focused on the parameterization of this condition in slab elements. The present study aims to use the inductive test method in cubic cores sawn from a slab made of steel fiber reinforced self-compacting concrete. As result, the inductive method was able to assess the variation in the fiber concentration and the fiber orientation in each core. The use of the individual cubes measured results turn possible to draw flow lines that point to the influence of the casting in the preferred fiber orientation and concentration.

Documentos Relacionados