Avaliação de clones de seringueira (Hevea spp.) em Piracicaba-SP / Rubber tree (Hevea spp.) clones evaluation in Piracicaba - SP

AUTOR(ES)
DATA DE PUBLICAÇÃO

2008

RESUMO

Piracicaba-SP is on the extreme southern region suitable for rubber planting in Brazil, with little information on the performance of clones under its environmental conditions. The performance of growth and yield of ten rubber tree clones (Hevea spp.) were evaluated. The studied clones were CATI 21, IAC 15, IAN 873, GT 1, PB 235, PB, 252, PR 107, PR 261, RRIM 526 and RRIM 600. The trial was established in the experimental field of de Crop Production Department of the ESALQ/USP, at Piracicaba-SP, Brazil, under complete randomized block design with five replications. It was assessed the number and percentage of trees under tapping and yearly rubber yield. Tapping started at the trees age of 6,5 years, with the ½ S d/7 9m/y ET 3.3% 9/y exploitation system. IAN 873 and PB 252 were the highest producers, out-yielding RRIM 600, which presented similar yield then CATI 21 and IAC 15. PR 107 and GT1 had intermediate yield, immediately below the formers, but with good secondary characteristics as late and increasing growth and yield. PB 235, unexpectedly, was a low yielder. RRIM 526 was immediately below PB 235 without any attractive characteristic to recommend it. PR 261 presented the lowest yield. IAN 873, PB 252, RRIM 600, because their good performance in the experiment and their widely-tested good performance elsewhere, should be recommended for commercial planting in large scale. CATI 21 and IAC 15, because their good performance in the experiment, should be recommended for commercial planting in small scale. PR 261 should not be recommended for commercial planting in Piracicaba.

ASSUNTO(S)

hevea spp. rubber tree cultivars. borracha clonagem clones variedade vegetal. yield produção vegetal seringueira rubber

Documentos Relacionados