Application of an alternative mesh morphing method on the numerical modeling of oscillating wave surge converters

AUTOR(ES)
FONTE

RBRH

DATA DE PUBLICAÇÃO

29/07/2019

RESUMO

RESUMO Uma das tecnologias capazes de explorar a energia das ondas, baseada na captação das componentes horizontais do movimento destas, aliada a um sistema placa-pistão, vem experimentando um notável desenvolvimento ao longo dos últimos anos, tal dispositivo é conhecido como conversor oscilante por translação de ondas. Este possui um grande potencial, já comprovado, de geração de eletricidade. Uma das maneiras mais utilizadas para a análise destes conversores consiste na aplicação de ferramentas de modelagem numérica computacional. Neste contexto, o presente trabalho propõe a aplicação de uma metodologia numérica alternativa de deformação da malha de cálculo para representar a hidrodinâmica destes dispositivos, a qual está baseada em um fundo que oscila juntamente com o conversor, permitindo que este atinja inclinações elevadas, sem ocasionar divergências numéricas. O estudo é realizado pela aplicação do código computacional OpenFOAM, em conjunto com sua extensão OLAFOAM, que, através da metodologia Volume of Fluid (VOF), para a representação da superfície livre, e do método das médias de Reynolds (RANS), para a modelagem da turbulência, possibilita a simulação bidimensional da dinâmica do conversor considerado. O método proposto mostrou boa concordância e representatividade dos resultados, quando comparados a estudos experimentais, presentes na literatura, em situações hidrodinâmicas similares. Além disto, a metodologia baseada em um fundo móvel apresentou diferenças relativas, em relação ao método que considera o fundo como fixo, entre 4% e 17% para casos de placa muito próximos ao fundo do domínio e de até 8% para os casos onde esta encontra-se mais afastada.ABSTRACT A technology capable of converting the horizontal motion of the ocean waves into energy by the application of a flap-piston system has been improved over the last few years, this device is known as oscillating wave surge converter. This system has great potential, already proven, for electric power generation. The computational fluid dynamics is one of the most used tools for the study of wave energy converters. In this context, the present paper proposes the application of an alternative mesh morphing method to represent the hydrodynamics of these devices, which is based on a bottom that oscillates with the converter, leading the flap to reach high inclinations without causing numerical divergences. The study is performed using the OpenFOAM computational code and its extension OLAFOAM. These are based on Reynolds Average Navier Stokes (RANS) turbulence modeling and the Volume of Fluid method (VOF) for the free surface representation, which are applied to a bidimensional model, allowing the numerical modeling of the converter. The proposed method presented good agreement of the results when compared to the experimental studies in similar hydrodynamic cases. The methodology based on a moving bottom presented relative differences, concerning the method that considers the bottom as fixed, between 4% and 17% for the cases where the flap is near to the ocean bottom and up to 8% for cases where it is further away.

Documentos Relacionados