Analysis of the Dynamic Stability of Ball-End Milling of AISI D6 Hardened Steel

AUTOR(ES)
FONTE

Mat. Res.

DATA DE PUBLICAÇÃO

02/12/2019

RESUMO

AISI D6 hardened steel is a difficult to cut material that it is employed in mould and die manufacturing where long ball-end mills are frequently required to machine deep cavities. This condition can lead to excessive vibration between tool and workpiece resulting in a poor surface finishing and reduced tool life. This work analyses the dynamic stability of ball-end milling of AISI D6 hardened steel for different tool path orientations at inclined workpiece angles of 15º and 75º. The evaluation of stability is based on the surface texture and spectrum analysis of the vibration signals. The results showed that for workpiece inclination angle of 15º chatter occurred in vertical upward down-milling and vertical downward up-milling. Best surface texture with tool marks consistent with pick feed and feed directions were generated by applying horizontal downward tool paths that produced the least vibration. Only forced vibrations occurred for the workpiece inclination angle of 75º. The highest peaks of the spectra corresponded to the harmonics of the tooth passing frequency closer to the natural frequency of the system. High magnitudes in the spectrum were found for vertical upward down-milling that generated a less uniform surface texture.

Documentos Relacionados