Aeroelastic Modeling
Mostrando 1-10 de 10 artigos, teses e dissertações.
-
1. Comparison of In-Flight Measured and Computed Aeroelastic Damping: Modal Identification Procedures and Modeling Approaches
ABSTRACT The Operational Modal Analysis technique is a methodology very often applied for the identification of dynamic systems when the input signal is unknown. The applied methodology is based on a technique to estimate the Frequency Response Functions and extract the modal parameters using only the structural dynamic response data, without assuming the kn
J. Aerosp. Technol. Manag.. Publicado em: 2016-06
-
2. Virtual boundary method applied to a problem of computational aerolastic analysis / Método da fronteira virtual aplicado em um problema de análise aeroelástica computacional
The behavior study of a profile of a typical aerolastic section, with Reynolds in range of micro aerial vehicle, is the main focus of this work, taking as objective the estimation of parameters of flutter phenomenon. The research analyzes of the flow of a incompressible fluid on a body (cylinder and airfoil profile) at steady state and oscillating with const
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 18/02/2011
-
3. Uma comparação de métodos para avaliar a resposta dinâmica de edifícios altos em túnel de vento / A comparison of methods for assessing the dynamic response of tall building in wind tunnel
Atualmente, o cenário econômico mundial compreende a exploração cada vez mais intensa dos espaços urbanos, através de edificações que buscam maximizar a relação entre área construída e área disponível. Estas edificações, mais flexíveis e mais altas, dependem de avanços no uso de sistemas estruturais inovadores e materiais de elevada resist�
Publicado em: 2011
-
4. Aeroelastic modeling and experimental analysis of a flexible wing for wind tunnel flutter test.
The objective of this work is to investigate the flutter phenomena experimentally, which will unify high aspect ratio wings design for wind tunnel flutter tests (Dowell and Tang, 2002), cheaper aeroelastic models construction and a procedure used by Sheta, Harrand, Thompson and Strganac (2002) to identify the flutter onset power spectral density versus the f
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 06/12/2010
-
5. Aeroelastic modeling and experimental analysis of a flexible wing for wind tunnel flutter test.
The objective of this work is to investigate the flutter phenomena experimentally, which will unify high aspect ratio wings design for wind tunnel flutter tests (Dowell and Tang, 2002), cheaper aeroelastic models construction and a procedure used by Sheta, Harrand, Thompson and Strganac (2002) to identify the flutter onset power spectral density versus the f
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 06/12/2010
-
6. Linear and nonlinear aeroelastic analyses of a typical airfoil section with control surface freeplay.
This work presents an extensive analysis on the linear and nonlinear behavior of three degrees of freedom typical airfoil section oscillating in a bidimensional incompressible flow. The nonlinearity is introduced by means of control surface freeplay. The theoretical modeling of the aeroelastic system is reviewed from structural and aerodynamic standpoint. Tw
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 07/07/2010
-
7. Linear and nonlinear aeroelastic analyses of a typical airfoil section with control surface freeplay.
This work presents an extensive analysis on the linear and nonlinear behavior of three degrees of freedom typical airfoil section oscillating in a bidimensional incompressible flow. The nonlinearity is introduced by means of control surface freeplay. The theoretical modeling of the aeroelastic system is reviewed from structural and aerodynamic standpoint. Tw
Publicado em: 2010
-
8. State-Space modeling and active aeroelastic control of a typical airfoil section with three degrees of freedom.
This dissertation presents a detailed analysis of a typical section model with three degrees of freedom. This is a classic model used for the study of basic aerodynamic and aeroelastic phenomena. The equations of motion are derived and discussed. The equations for the aerodynamic loads induced by arbitrary motion of the typical section and by arbitrary shape
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 10/09/2008
-
9. Aeroservoelastic analysis of the blade-sailing phenomenon in the helicopter-ship dynamic interface.
This thesis proposes a Rotary-Wing Aeroservoelasticity approach to the modeling, analysis and control of the blade-sailing phenomenon in the helicopter-ship dynamic interface (DI), based on the identification, response evaluation and control of flow and ship motion induced loads, during the engagement/disengagement flight regimes, in order to establish some
Publicado em: 2007
-
10. Numerical solution of the Euler equations for representation of transonic flows over airfoils / Solução numérica das equações de Euler para representação do escoamento transônico em aerofólios
The study of aerodynamic modeling methods for the transonic flow regime is of great importance in aeronautical engineering. Major challenge on the treatment of those flows is on their nonlinear features due to compressibility effects and shock waves (appearance). Such nonlinear effects present a strong influence on aerodynamic performance, as well as they ar
Publicado em: 2003