Optical Amplifiers
Mostrando 1-12 de 64 artigos, teses e dissertações.
-
1. Study and Optimization of Raman Amplifiers in Tellurite-Based Optical Fibers for Wide-Band Telecommunication Systems
Abstract Here we present a numerical analysis and the optimization of a multi-pump discrete Raman amplification system based on the use of a Tellurite optical fiber as the gain media. By using previously reported optimization techniques we were able to exploit the high Raman gain of Tellurite optical fibers and its multipeak spectrum to achieve amplification
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 19/06/2019
-
2. A simple strategy to design broadband low power consumption distributed Raman amplifier
Abstract In this work, a simple strategy to design wideband low power consumption Raman amplifiers is demonstrated for a three-pump configuration using a low water peak optical fiber. The approach is based on the introduction of a novel numerical measure, which quantifies and isolates pump-pump interaction contribution to gain profile and analyzes its correl
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2017-09
-
3. Experimental-based subsystem models for simulation of heterogeneous optical networks
This work presents and analyzes experimental-based subsystem models for Erbium doped fiber amplifiers (EDFAs) and wavelength selective switches (WSSs) under operation in a metropolitan optical network testbed. Firstly, the performance of the EDFAs and two gain control types are analyzed in a heterogeneous experimental setup with lightpaths modulated at 10G/1
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2014-12
-
4. Hybrid distributed Raman/EDFA amplifier with hybrid automatic gain control for reconfigurable WDM optical networks
Nowadays, optical amplifiers designs are induced by new requirements generated by optical networks. The introduction of WDM reconfigurable networks with increasing rate from 10-40 Gb/s to 100 Gb/s and beyond, demand new optical amplifiers development with improved gain spectral flatness and noise figure for all operational range of input powers and set-point
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2013-12
-
5. Determining the Fixed Pattern Noise of a CMOS Sensor: Improving the Sensibility of Autonomous Star Trackers
ABSTRACT: Autonomous star trackers are optical-electronic devices used for attitude determination of artificial satellites, having as a reference for this computation the positions of stars. There is one autonomous star tracker in development at the Aerospace Electronics Division of the Brazilian National Institute for Space Research. The autonomous star tra
J. Aerosp. Technol. Manag.. Publicado em: 2013-06
-
6. Espectroscopia ultrarrápida do polímero semicondutor luminescente MEH-PPV com excitação no ultravioleta / Ultrafast spectroscopy of the luminescent semiconducting polymer MEH-PPV with ultraviolet excitation
The optoelectronics industry is currently undergoing a transition period in which inorganic materials are being replaced by organic materials, oligomers and polymers, in the fabrication of some types of devices. However, factors such as low efficiency and low lifetime prevent polymer based devices on entering the market definitely. The solution of these issu
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 17/08/2012
-
7. Sistemas de sensores ópticos baseados em fibra óptica de perfil-W dopada com Érbio / Optical sensing systems based on Erbium-doped W-fiber
Depressed-cladding (often referred to as dual-clad or "W"- fiber) fibers with fundamental-mode cutoffs provide high distributed losses at long wavelengths and low losses at short wavelengths. The magnitude of the abrupt transition between low-loss at short wavelengths and high-loss at long wavelengths exceeds 200 dB/km and is found to be extremely sensitive
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 30/07/2012
-
8. Degradação de sinais com modulação NRZ-DQPSK e 16-QAM em enlaces ponto a ponto com amplificadores ópticos a semicondutor = : NRZ-DQPSK and 16-QAM signal degradation in fiber links with semiconductor optical amplifiers / NRZ-DQPSK and 16-QAM signal degradation in fiber links with semiconductor optical amplifiers
Modulações ópticas avançadas como DQPSK e QAM tem sido escolhidas por serem formatos multiniveis (dois bits ou mais por símbolo), aumentando a eficiência espectral de sistemas ópticos. Entretanto, o amplificador óptico a semicondutor (SOA) indicado principalmente para aplicações de media distancia (da ordem de 20 km), pode degradar o sinal DQPSK e
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 26/07/2012
-
9. Geração de sinais ópticos multi-níveis a partir de amplificação paramétrica em fibras ópticas / Optical signals multi-levels generation through parametric amplification in optical fibers
Neste trabalho foram investigadas através de experimentos e simulações computacionais duas novas técnicas de processamento óptico de sinais, que utilizam amplificação paramétrica para multiplexar as informações de dois sinais binários em um único sinal multi-nível. Na primeira delas, o sinal multi-nível corresponde a um sinal quaternário em am
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 15/08/2011
-
10. Conversão em comprimento de onda de sinais modulados em fase por mistura de quatro ondas em SOAs / Wavelength conversion of phase modulated channels by four-wave mixing in SOAs
Recently semiconductor optical amplifiers (SOAs) have been the focus of interest in several applications. One of the most common SOA roles is as a wavelength converter, where the device transfers information content among optical carriers in the optical domain. Four wave mixing (FWM), cross-gain modulation (XGM), and cross-phase modulation (XPM) are major no
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 15/04/2011
-
11. Design of distributed optical-fiber raman amplifiers using multi-objective particle swarm optimization
A novel method is presented to design the configuration of pumping lasers of Raman amplifiers using a multi-objective particle swarm optimizer. The goal is to obtain the pump laser wavelengths and powers that maximize the amplifier on-off gain, while maintaining the flatness of the gain over the used bandwidth. We used an algorithm called Multiple Objective
Journal of Microwaves, Optoelectronics and Electromagnetic Applications. Publicado em: 2011-12
-
12. Transmission of a 20 Gb/s NRZ OOK signal throughout a 390 km fiber link and a cascade of 11 x 50 GHz filters and 9 x EDFAs
This paper presents a qualitative analysis of the impact caused by fiber propagation effects and by a cascade of optical filters, designed for 10 Gb/s NRZ OOK transmission, and optical amplifiers on a 20 Gb/s NRZ OOK optical signal traveling a 390 km fiber link. The choice for such bit rate and modulation format has been driven by the 50 GHz bandwidth of the
Journal of Microwaves, Optoelectronics and Electromagnetic Applications. Publicado em: 2011-06