Composite
Mostrando 1-12 de 3331 artigos, teses e dissertações.
-
1. Regional analgesia and surgical site infections after colorectal surgery: a retrospective cohort analysis
Abstract Background The effect of regional analgesia on perioperative infectious complications remains unknown. We therefore tested the hypothesis that a composite of serious infections after colorectal surgery is less common in patients with regional analgesia than in those given Intravenous Patient-Controlled Analgesia (IV-PCA) with opiates. Methods Pati
Brazilian Journal of Anesthesiology. Publicado em: 2023
-
2. Experimental analysis of walking induced vibrations in composite floor and performance evaluation considering human confort
Resumo A NBR8800 foi atualizada no ano de 2008. Os critérios de aceitação de desempenho de sistemas de piso e passarelas considerando conforto humano às vibrações foram simplificados e apenas valores mínimos de frequência fundamental são considerados para avaliação de desempenho. O objetivo deste artigo é avaliar uma metodologia de análise exper
Ambiente Construído. Publicado em: 2023
-
3. Study of Catalytic Pyrolysis of Biomass Sorghum (Sorghum bicolor L. Moench) Using Design of Experiments and Surface Response Methodology
This study proposes a screen of variables that have an influence on the modification of the bio-oil chemical composition as a unique critical quality attribute (CQA) throughout the pyrolytic process (zeolite, ZSM-5) by using a 24 full factorial design, followed by optimization through a response surface methodology (RSM) based on central composite design (CC
Journal of the Brazilian Chemical Society. Publicado em: 2023
-
4. Association between enhanced recovery after surgery protocol compliance and clinical complications: a cohort study
Abstract Background Enhanced Recovery After Surgery (ERAS) protocol is composed by evidence-based interventions that aim to improve recovery through a reduction in surgical stress response. Although ERAS protocols have been introduced across the globe, exhaustive implementation is not as common. We aimed to study the ERAS protocol compliance in colorectal s
Brazilian Journal of Anesthesiology. Publicado em: 2023
-
5. Growth phenotypes of very low birth weight infants for prediction of neonatal outcomes from a Brazilian cohort: comparison with INTERGROWTH
Abstract Objective: To assess the predictive value of selected growth phenotypes for neonatal morbidity and mortality in preterm infants < 30 weeks and to compare them with INTERGROWTH-21st (IG21). Methods: Retrospective analysis of data from the Brazilian Neonatal Research Network (BNRN) database for very low birth weight (VLBW) at 20 public tertiary-care
Jornal de Pediatria. Publicado em: 2023
-
6. Optimum design of steel columns filled with concrete via genetic algorithm: environmental impact and cost analysis
Abstract The use of concrete-filled tubular columns as part of structural systems has steadily increased throughout the years. The growing demand for structural elements of this nature is a direct result of the possibility to use various cross-section shapes that have increased strength, along with resistance to fire and other corrosive agents. The main obje
REM - International Engineering Journal. Publicado em: 2022
-
7. Learning Curve in Left Ventricular Assist Device Implantation: Low Volumes Do Not Equate Bad Outcomes
ABSTRACT Introduction: Most implantations of left ventricular assist devices (LVAD) are performed in low-volume centers. This study aimed to evaluate the procedural learning curve of HeartMate II (HM2) implantations by comparing outcomes between two time periods in a low-volume center. Methods: All 51 consecutive patients undergoing HM2 implantation betwee
Brazilian Journal of Cardiovascular Surgery. Publicado em: 2022
-
8. Effect of sintering temperature on mechanical and bioactivity properties of bioactive glass and cordierite composite
Abstract In this study, a composite of bioactive glass (BG) and cordierite (BG-cord) was proposed to increase the strength and bioactivity of BG. Both BG and cordierite were separately synthesized with the method of glass melting, then, they were used to fabricate BG-cord with a variation of sintering temperature (600 to 1000 °C). The highest diametral tens
Cerâmica. Publicado em: 2022
-
9. Mechanical properties and fractography of cement-based composites reinforced by natural piassava and jute fibers
Abstract Today’s demand for environmentally friendly and energy-efficient solutions to the construction industry has driven researchers to match natural resources with traditional technics to develop new building technologies. However, there are literature limitations about the correlation of fiber-matrix interface with the failure of natural fibers in mor
Cerâmica. Publicado em: 2022
-
10. Challenges of TiO2-composite, as a visible active photocatalyst material for SARS-CoV-2 antiviral compared with the other viruses
The efforts in dealing with COVID-19 in various aspects are continuously being carried out, such as the photocatalytic process. Interestingly, TiO2 plays an important role as an environmentally friendly photocatalyst with a visible and UV absorption range. The increase in the antiviral performance of this compound is further maximized by formulating TiO2-bas
Química Nova. Publicado em: 2022
-
11. Intra- and interobserver agreement of histopathological findings in pediatric patients with eosinophilic esophagitis
Abstract Objective: To assess intra- and interobserver agreement among non-expert pathologists in identifying features of the eosinophilic esophagitis histologic scoring system (EoEHSS) in pediatric patients. Patients and methods: The authors used 50 slides from patients (aged 1-15 years; 72% male) with EoE. EoEHSS evaluates eosinophilic inflammation and o
Jornal de Pediatria. Publicado em: 2022
-
12. Production of nanostructured crystalline composite using residual ashes from flocculated sludge burning process in a poultry slaughterhouse wastewater treatment system
Abstract Nanostructured crystalline composite (activated carbon) was synthesized from residual ashes of the burning process of the sludge generated in the flotation step of a poultry slaughterhouse and was used for Allura red dye adsorption. The ashes were chemically activated using two types of reagents, H2O2 and H3PO4, and the structure, morphology, and su
Cerâmica. Publicado em: 2022